Close
Login to Your Account
Shaarp Mind Forum



Page 1 of 3 123 LastLast
Results 1 to 7 of 15
  1. #1
    niklos
    only flash with attached eeprom file..............donetitle=smile


    COM8 [VCP0] selected

    module v2.91

    Device: Autodetect 6205-6227 NOR

    Checking data* wait...

    advanced flash detection enabled

    Action: write NOR flash

    smart write active

    skip: Firmware

    skip: Customization/Language Pack

    skip: Customization

    write: Eeprom/ffs

    T600_V04_PCB01_GPRS_MT6225_S00.T600_V04_ENFRARRUSP PEVI_SIGMATEL__Sigmatel-s88.B0E.bin

    ffs/eeprom backup enabled* it may takes several minutes !

    Boot ...

    Press and HOLD Power button now !

    19200 fixed

    Connecting* wait...

    Initializing [6225:8A05:8A00]...

    CPU: MT6225

    high speed boot On

    chip: 0001:1C03:0002

    status: FF

    boot packet size: 0400

    Release Power button now !

    Boot Done

    Initialize ...

    detecting chip #00 in region #00...

    flash: 2088C4FFFFFFFF:2088C400000000

    flash: ST Intel/Sharp ext [def 007Fx020000 0004x008000] 16Mb

    detecting chip #01 in region #00...

    flash: 2088C4FFFFFFFF:2088C400000000

    flash: ST Intel/Sharp ext [def 007Fx020000 0004x008000] 16Mb

    detecting chip #02 in region #00...

    flash: 2088C4FFFFFFFF:2088C400000000

    flash: ST Intel/Sharp ext [def 007Fx020000 0004x008000] 16Mb

    detecting chip #03 in region #00...

    flash: 2088C4FFFFFFFF:2088C400000000

    flash: ST Intel/Sharp ext [def 007Fx020000 0004x008000] 16Mb

    number of flash chip/regions detected: 04/01

    Initialize Done

    Set baud ...

    460800

    Set baud Done

    Initialize bootcode ...

    Initialize bootcode Done

    Check firmware integrity ...

    device parameters autodetection in progress...

    detecting chip #00 in region #00...

    flash: 2088C4FFFFFFFF:2088C400000000

    flash: ST Intel/Sharp ext [def 007Fx020000 0004x008000] 16Mb

    detecting chip #01 in region #00...

    flash: 2088C4FFFFFFFF:2088C400000000

    flash: ST Intel/Sharp ext [def 007Fx020000 0004x008000] 16Mb

    its time to stop: 18F09FE518F09FE518F09FE518F09FE518F09FE518F09FE5

    number of flash chip/regions detected: 01/01

    total flash region size: 01000000

    detect device rom info...

    detection phase #1...

    detect device rom info finished

    rom info structure: 2nd [standard] generation

    rom info detection finished

    rom info protocol ver: 04

    ver. sw 1: T600_V04_PCB01_GPRS_MT6225_S00.T600_V04_ENFRARRUSP PEVI_SIGMATEL.BIN

    ver. sw 2: T600_V04_EnFrArRuSpPeVi_SIGMATEL* 00000000

    ffs offset/size: 00E00000/00200000

    detecting ffs/eeprom area in 1 chip(s)...

    standard ffs/eeprom offset detected: 00E00000

    flash: 2088C4FFFFFFFF:2088C400000000

    checking area [00000000]: 00000000-00FFFFFF...

    ffs/eeprom found near: 00E00000

    detecting ffs/eeprom size...

    ffs/eeprom size: 00200000

    ffs/eeprom chip: 00

    ffs/eeprom area: 00000000:00E00000-00FFFFFF

    detect device sec info...

    detection phase #1...

    .

    detect device sec info finished

    Check firmware integrity Done

    Check firmware content ...

    Check firmware content Done

    Backup required data ...

    reading: T600_V04_PCB01_GPRS_MT6225_S00.T600_V04_ENFRARRUSP PEVI_SIGMATEL__ffs...

    file saved: E:InfinityBoxChineseMiracleT600_V04_PCB01_GPRS_ MT6225_S00.T600_V04_ENFRARRUSPPEVI_SIGMATEL__ffs_2 0090928-022338.B0E.bin

    flash: 2088C4FFFFFFFF:2088C400000000

    Backup required data Done

    Patch required data ...

    Patch required data Done

    Special operation ...

    Special operation Done

    Write ...

    Area: Eeprom/ffs

    flash: 2088C4FFFFFFFF:2088C400000000

    Write: Eeprom/ffs

    detect device sec info...

    detection phase #1...

    .

    detect device sec info finished

    Write Done

    Finalization ...

    Finalization Done

    Finished* time used: 263 sec

    Remove/Install battery now !

  2. #2
    ..::Noman::..
    hello!
    was it tochscreen not calibrated?
    did you try to solve it by bypass touchscreen calibration ?

  3. #3
    ORACHI
    Quote:
    InfinityHelp / hello!
    was it tochscreen not calibrated?
    did you try to solve it by bypass touchscreen calibration ? it is not tuch screen calibration problem ........first of all i tried clibration tuch screen option (all mode) ..............but not fixed........then problem solved flashing with eeprom file

  4. #4
    omegafones
    hello!
    i will add this file to support with a name
    T600_V04_PCB01_GPRS_MT6225_S00.T600_V04_ENFRARRUSP PEVI_SIGMATEL__Sigmatel-s88_eeprom_for_not_calibrated.B0E.bin

  5. #5
    CDX
    yes for me working 100000000000000% perfect sloution
    thank you very much MR.

  6. #6
    pava
    How to write this eeprom file with spiderman box? I got error while flashing eeprom. please help?

  7. #7
    spider-man
    Not possible when using spiderman. This eeprom can only be used in Infinity.

Page 1 of 3 123 LastLast

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. GPGDragon - Sigmatel NXP CPU ( solved )
    By DeVo in forum GPGDragon
    Replies: 2
    Last Post: 12-31-2011, 10:55 PM
  2. sigmatel t99
    By NOKIA127 in forum Infinity-Box
    Replies: 1
    Last Post: 06-04-2011, 03:39 AM
  3. Sigmatel V88
    By cellPhoneIdea in forum China Phones
    Replies: 0
    Last Post: 05-19-2011, 09:07 PM
  4. sigmatel s1
    By kris in forum China Phones
    Replies: 3
    Last Post: 05-19-2011, 09:06 PM
  5. Sigmatel exd t3 sim way help
    By TechnicianJay in forum China Phones
    Replies: 0
    Last Post: 05-19-2011, 09:01 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •